The working principle of the volcanic gray grinding machine: spray the volcanic gray abrasive material on the nylon brush, and use the nylon brush to the surface of the substrate to obtain the surface treatment equipment on the rough surface. , Chemical/tin/silver, processing processes.
Its basic structural process: pickling-circulating water washing-city water washing-grinding brush-elegant water washing-absorbing-drying section
The operation of the volcanic gray grinding machine is simple, but there are some processes still need to pay attention:
1. Check the power supply, gas source, and water source before booting. Whether the grinding machine storage pool is full and check whether the spray turtle is blocked. After turning on the grinding board electrical source switch for about 2 minutes, the main written writing is displayed. This matter is pressed for the "Start" key, the template is in a preparation state, click the automatic running key, heated it by itself, stir on the volcanic gray cylinder, the "warning" light at the plate is on, about about approximately, about about After 5 minutes, the grinding machine is prepared to complete the "warning" light.
2. Add 25kg of volcanic ash when opening the cylinder, and the volcanic ash content is controlled at 12-18%for each production of 8000-10000panls.
Take the volcanic ash paddle liquid for 15 minutes with a 100ml measuring cylinder to observe whether the bottom volcanic ash has not accounted for 12-18%of the entire volume. The content is checked every 4 hours.
3. Add H2SO45L in the acid washing cylinder, control the concentration at 3-5%, change the shift once, the pressure is maintained at 15-2.5kg/cm2, and the picking segment speed is controlled at 0.5-5 units.
Features of volcanic gray mills:
1. Simple operation: There are two types of control brush mode: automatic and manual. When automatic operation, you only need to set the grinding brush current. The machine can automatically adjust the grinding brush according to the changes in the current.
2. Design special disassembly brush tools to ensure that any milling brush is replaced within 5 minutes;
3. Special abrasive brush and transmission structure design. The smart brush function (with three modes of thinness, medium, and thick) is combined with the German SEW high -quality motor to obtain the ideal rough surface.
